Set Up The Airstation As A Repeater - Buffalo AirStation WZR-900DHP User Manual

8
You can also manually select the access point by opening the Manual Connection page. Select the access point
from the available list of detected wireless access points. Set the wireless authentication and encryption to match
that of the access point and click OK. If the access point is not displayed, click Search Again to refresh the list. After
you are returned to the Wireless Bridge page, click Apply.
The AirStation should now be connected as a wireless extender. Configure the AirStation's SSID and security settings
on Wireless - 2.4 GHz (or 5 GHz). Once you are finished, you can disconnect the Ethernet cable and move the AirStation
to another location that is within range of the access point. Other devices can now connect to the AirStation to use the
Internet.

Set Up the AirStation as a Repeater

If the AirStation is set as a repeater, it will rebroadcast an existing wireless signal and only use the access point's SSID
and security settings. Devices within range of both the access point and the AirStation will automatically connect to the
stronger signal.
1
Set the mode switch on the back of the AirStation to "WB".
2
Connect the AirStation to a computer with an Ethernet cable.
3
Move the AirStation next to the wireless access point.
4
Open a web browser and enter the AirStation's IP address (default is 192.168.11.100).
5
Enter the administrator password and log in.
95