Page 1
To reset the router, please insert “RESET” hole by a paper clip for Power on Buffalo Router, and wait for 1 minutes. The “Power”, “n” and about 10 seconds, and wait for 1 minutes. The “Power”, “n” and “Router” indicators will be ON, and other indicators will be OFF.
WZR-AGL300NH Router Settings (For : Pccw, HGC PPPoE User) Prepare for Buffalo Router installation (Windows XP) Click “Start” Click “Control Panel” or “Settings” -> “Control Panel” Choose “Internet Options” or “Network and Internet Connections” -> “Internet Options” Click “Connections” tab, choose “Never dial a...
Page 3
WZR-AGL300NH Router Settings (For : Pccw, HGC PPPoE User) Under Control Panel, please choose “Network Connections” or “Network Highlight “Internet Protocol (TCP/IP)”, and then click “Properties”. Under and Internet Connections” -> “Networks Connections”, then right-click “Internet Protocol (TCP/IP) Properties”, choose “Obtain an IP address...
Page 4
WZR-AGL300NH Router Settings (For : Pccw, HGC PPPoE User) Buffalo Router WZR-AGL300NH Internet Connection Settings: Router is now detecting Internet Connection. Open Web Browser, under address bar, please type http://192.168.11.1, and press “Enter”. Login dialog box will be prompted. Input: Username root, Password: no password by default 4.
Page 5
WZR-AGL300NH Router Settings (For : Pccw, HGC PPPoE User) Choose “Set Router Mode ON” Please input the login username (e.g. xxxx@netvigator.com xxxx@hgcbroadband.com) and password (twice) of your broadband service now. Then click “Next” Choose “PPPoE Connection” “Check the Internet connection” process is successful, the following page will be displayed.
Page 6
WZR-AGL300NH Router Settings (For : Pccw, HGC PPPoE User) If the login information is incorrect, the following page will be displayed. Please confirm login information. Click “Back” button to return previous page, re-enter login username/password (twice), and then click “Next” to check internet connection again.
Page 7
WZR-AGL300NH Router Settings (For : Pccw, HGC PPPoE User) Buffalo Router WZR-AGL300NH Wireless Connection Settings: Wait for 1 minute. Buffalo Router WZR2-G300N Wireless Connection Settings: Launch Web Browser, enter http://192.168.11.1 in address bar and then press Enter. Then type username as “root”, default no password.
Page 8
WZR-AGL300NH Router Settings (For : Pccw, HGC PPPoE User) On “Setup” page, click “Wireless Encryption (WEP/TKIP/AES)” Click “WEP” To secure your wireless network, you can setup wireless encryption on this page. - Set “WEP Encryption Key” to ”Character Input: 13 characters (WEP128)”.
Page 9
WZR-AGL300NH Router Settings (For : Pccw, HGC PPPoE User) On “Setup” page, click “Wireless SSID & Channel(11n300MHz Mode) ” Click “Complete” and return to “Setup” page Under “Wireless SSID and Wirless Channel Settings” page, the SSID (wireless network signal name), and Wireless Channel can be changed.
Page 10
WZR-AGL300NH Router Settings (For : Pccw, HGC PPPoE User) Wait for 1 minute. Click "Settings Complete" and return to "Setup" Page. <Setup Complete.> Last Update Apr 16, 2009 Hornington Knowledge Base http://kb.hornington.com WZR-AGL300NH PPPoE Page 10...