Buffalo AirStation WZR-900DHP User Manual page 9

1
AOSS button
To initiate AOSS, hold down this button until the wireless LED flashes (about 1 second). Then, push or click the
AOSS button on your wireless client device to complete the connection. Both devices must be powered on.
2
Power/Diag LED (Green or Red)
On (Green):
Power is on.
On (Red):
The AirStation is in wireless bridge mode.
Blinking (Green):
Booting.
Off:
Power is off.
2 blinks (Red)**:
Flash ROM error.
3 blinks (Red)**:
Wired LAN error.
4 blinks (Red)**:
Wireless LAN error.
5 blinks (Red)***:
IP address setting error.
Continuously blinking*:
Updating firmware, saving settings, or initializing settings.
* Do not unplug the AC adapter while the LED is blinking continuously.
** Turn off AirStation first, wait for a few seconds, then turn it back on.
*** WAN-side and LAN-side IP addresses are the same. Change the LAN-side IP address of the AirStation.
3
Wireless LED (Green or Amber)
On:
Wireless LAN is enabled or transmitting.
Double blinks:
AirStation is waiting for an AOSS or WPS security key.
Continuously blinking (fast):
AOSS/WPS error; failed to exchange security keys.
Continuously blinking (slow):
The AirStation is in wireless bridge mode.
Off:
Wireless LAN is disabled.
Note: The wireless LED will be green if security is enabled or amber if it is disabled.
4
Internet Access LED (Green)
On:
The WAN port is connected.
Off:
No Internet access.
5
Router LED (Green or Amber)
On (Green):
Router functionality is enabled.
Off:
Router functionality is disabled.
9