Midi Control-Modes Of Operation - ALLEN & HEATH GS-R24 User Manual

MIDI CONTROL MODES OF OPERATION
SOLO/
SELECT
SOLO MODE
PFL MODE
SIP
OFF = SEL MODE
AFL MODE
ADD MODE
SOLO
CLEAR
GS-R24M GS-R24
READ
MONO CH
MOTOR FADERS MIDI ENABLED
MONO O/P
WRITE
MIDI FADER MODE
OFF = NO FADER MIDI
Allen & Heath
SOLO/SELECT switches in SEL mode
If the Solo mode is set to SEL (both PFL and AFL mode switches set to
their up position, then the channel Solo switches function as MIDI select
switches primarily designed to map to DAW functions such as track
solo, track mute or record arm.
Pressing the switch will send a MIDI message via the MIDI out on the
interface module which can either be mapped, learned or translated by
the DAW or computer software.
The LED illumination of the switch can be set to either follow the
switch press only (internal tally) or to follow the status of the function
mapped in software by responding to MIDI input (external tally). This is
set by the console mode configuration on power up described on page
37.
The Select switches can work in the same fashion as the PFL/AFL system
where in ADD mode more than one can be selected simultaneously,
otherwise pressing a Select switch will cancel any previously selected.
Also, the Solo Clear switch illuminates when any are active, and will
clear any selected.
M
MIDI FADER MODE switches
The fader mode switches configure the operation of the MIDI enabled
channel faders. The switches function differently depending on whether
you have the GS-R24M with motorised faders or the GS-R24 without
motorised faders.
Read/Mono Channel Fader enable switch
GS-R24M: When this switch is pressed the 24 mono input channel fad-
ers will read MIDI data from the MIDI input on the interface module
and if valid commands are received the motors will engage and move
the fader to the position required by the received data.
GS-R24: Enables MIDI data to be sent from the 24 mono input channel
faders to the MIDI output on the interface module. If not pressed then
no MIDI data will be sent from the mono input channel faders.
Write/Mono Master Fader enable switch
GS-R24M: This switch enables MIDI data to be sent from the 24 mono
input channel faders to the MIDI output on the interface module. If not
pressed then no MIDI data will be sent from the mono input channel
faders.
GS-R24: Enables MIDI data to be sent from the Mono bus master fader
to the MIDI output on the interface module. This allows a single
100mm fader to be used to control MIDI parameters. The fade function
on the Mono output signal is bypassed at unity gain when this switch is
engaged.
30
GS_R24 User Guide