Getting Started; Accessory List; Turning Power On And Off; Source Selection - Alpine CDE-HD148BT Quick Reference Manual

Getting Started

Rotary encoder

/ENTER
/ 
AUDIO/SETUP
SOURCE
e

Accessory List

• Head Unit ..................................................................................1
• Power Cable ..............................................................................1
• USB Cable..................................................................................1
• Microphone ..............................................................................1
• Bracket Key ...............................................................................2
• Mounting Sleeve ......................................................................1
• Carrying Case............................................................................1
• Screw (M5 × 8) ..........................................................................4
• Owner's Manual..................................................................1 set

Turning Power On and Off

Press t to turn on the unit.
Note
• The unit can be turned on by pressing any other button except  and
e (Release).
• VSOURCE key blinks each time the unit is powered on.
Press and hold t for at least 2 seconds to turn off the
unit.
Note
• The first time power is turned on, the volume will start from level 12.

Source Selection

Press VSOURCE to change the source.
*1 *2
 SIRIUSXM
TUNER /HD RADIO
*4 *5
 BT AUDIO
USB AUDIO /iPod
*8
 TUNER/HD RADIO
AUXILIARY
*1 CDE-147BT only
*2 CDE-HD148BT only
*3 Displayed only when a SiriusXM Tuner is connected.
(CDE-HD148BT only)
*4 Displayed only when no iPod/iPhone is connected.
*5 Displayed only when the iPod/iPhone is connected.
*6 Displayed only when BT IN is set to ON, refer to "Setting the
BLUETOOTH Connection (BT IN)" on page 30.
*7 Not displayed when ALPINE APP is set to OFF, refer to "Setting
the communication mode with a Smartphone (ALPINE APP)"
on page 29.
*3
 DISC 
*6 *7
 PANDORA 
*8 Displayed only when AUX SETUP is set to ON. Refer to "Setting
the AUX SETUP mode" on page 27.

Detaching and Attaching the Front Panel

Detaching

1
Turn off the unit power.
2
Press e (Release) at the lower left side until the front
panel pops out.
3
Grasp the left side of the front panel and pull it out.
Notes
• The front panel may become hot in normal usage (especially the
connector terminals on the back of the front panel). This is not a
malfunction.
• To protect the front panel, place it in the supplied carrying case.
• When detaching the front panel, do not apply excessive force as it may
result in malfunction.

Attaching

1
Insert the right side of the front panel into the main unit.
Align the groove on the front panel with the projections
on the main unit.
2
Push the left side of the front panel until it locks firmly into
the main unit.
Notes
• Before attaching the front panel, make sure that there is no dirt or dust
on the connector terminals and no foreign object between the front
panel and the main unit.
• Attach the front panel carefully, holding the sides of the front panel to
avoid pushing buttons by mistake.
9
-EN