Cleaning Method; Product - Coway AP-1008CH User Manual

CLEANING METHOD

- Always unplug the air purifier before cleaning the product.
- Do not use detergents that contain organic solvents (solvent, thinner, etc),
Tips
bleach, chlorine, or abrasives.
- Do not put the air purifier in water or spray water directly on it.
■ Cleaning the pollution sensor (every 2 months)
1. Open the pollution sensor cover on the
right-hand side of the product. Clean
the air inlet and outlet vent and then
the pollution sensor with a soft brush or
vacuum cleaner.
2. Wet a cotton swab lightly and clean the lens, dust inlet,
and dust outlet. Clean them with a dry cotton swab
to remove remaining moisture.
∗ Without regular cleaning, the performance of the pollution sensor deteriorates.
∗ The cleaning cycle differs depending on the operation environment.
When using the product in a dusty environment, clean the sensor more often.
■ Cleaning the air inlet and outlet (every 2 months)
Clean the air inlet and outlet with a soft brush.
∗ Exercise caution not to have dust fall inside the air purifier.
■ Cleaning the front cover
Separate the front cover from the product and remove the dust
attached to the surface with a soft dry brush or cloth.
∗ Use lightly wet cloth if the contamination is serious but do not use abrasives.
■ Cleaning the product body (every 2 ~ 4 weeks)
Use dry, soft cloth to clean the product.
∗ Use lightly wet cloth if the contamination is serious but do not use abrasives.
Air outlet
▶
Dust outlet
Dust inlet
Air inlet
/
16