Performance Route Processor Overview; Prp Pcmcia Card Slots And Status Leds - Cisco XR 12410 Installation Manual

Line Card and Route Processor Overview

Performance Route Processor Overview

Figure 1-9 Performance Route Processor Front Panel
1
1
PCMCIA flash disk slots (shown with cover in
place) and slot LEDs
2 RJ-45 Ethernet ports and data status LEDs
3
Auxiliary serial port

PRP PCMCIA Card Slots and Status LEDs

Note
Cisco XR 12410 Router Installation Guide
1-16
The Secure Domain Router (SDR) controls domain security features independent
of any other SDRs on the network.
The performance route processor (PRP) uses a Motorola PowerPC 7450 CPU that
runs at an external bus clock speed of 133 MHz and has an internal clock speed
of 667 MHz.
Figure 1-9 identifies the slots, ports, and LEDs on the PRP front panel.
ETH 0
Two PCMCIA card slots (slot 0 and slot 1) provide the PRP with additional flash
memory capacity. All combinations of different flash devices are supported by the
PRP. You can use ATA flash disks, Type 1 or Type 2 linear flash memory cards,
or a combination of the two.
The PRP only supports +5.2 VDC flash memory devices. It does not support
+3.3 VDC PCMCIA devices.
Status LEDs (Slot-0 / Slot-1) indicate when the flash memory card in that slot is
accessed (see Figure 1-9). Each slot has an eject button (located behind the cover)
to remove a flash card from the slot.
Chapter 1
ETH 1 AUX CONSOLE
2 3 4
4
Console serial port
5 Reset button
6
Alphanumeric message displays
Cisco XR 12410 Router Overview
PERFORMANCE ROUTE PROCESSOR 1 (PRP-1)
5 6
OL-13832-01