Remote Commands - Radio Shack TAD-723 Owner's Manual

43-723.fm Page 12 Monday, May 22, 2000 10:26 AM

REMOTE COMMANDS

Press
1 Replay the current message.
1 1 Replay the previous message.
2 Play all or new messages.
3 Skip to the next message.
# 3 Change the remote security code. Enter a new 3-digit code.
4 Play OGM 1.
5 Play OGM 2.
# 4 Record OGM 1. Enter 0 to finish the recording and the TAD will play the new OGM 1 for
confirmation.
# 5 Record OGM 2. Enter 0 to finish the recording and the TAD will play the new OGM 2 for
confirmation.
# 6 Record memo. Enter 0 to finish the recording.
7 Delete the current message (during playback).
# 7 Delete all messages.
8 Monitor the room where the TAD is installed for 30 seconds.
9 Turn on/off the TAD. If the TAD is on it beeps twice when it answers.
0 Stops playback, including incoming messages, memos, and the OGM recording.
Hang up. The TAD announces, "The machine will now hang up."
Notes:
If your telephone line has CPC service and
you hang up while the TAD is playing back
the messages, it stops playback immediately
and resets to answer the next call.
If you do not have CPC service and you
hang up while the TAD is playing back the
messages, the TAD might not recognize that
you hung up. If someone calls while the TAD
continues to play the messages, the caller
hears a busy signal. We recommend that
you play all the messages or skip forward
through the messages using remote com-
12
To
mands until the TAD beeps once before you
hang up.
After you enter the correct security code the
TAD announces your command choices.
When you enter a remote command, the
TAD performs the operation immediately.
Press to end remote access, otherwise,
the TAD remains connected for about 1
minute, then disconnects.
Remote Operation