Setting The Incoming Message Length; Checking An Ogm; Setting The Number Of Rings - Radio Shack TAD-723 Owner's Manual

Digital telephone answering system with day/time voice stamp
Table of Contents

Advertisement

43-723.fm Page 8 Monday, May 22, 2000 10:26 AM
2. Hold down
ANNOUNCE
beep (about 2 seconds).
3. After the beep, begin speaking your
message about 8 inches away from the
microphone (located on the front of the
TAD).
4. Press
CODE/STOP
The TAD automatically repeats the mes-
sage then beeps.
SETTING THE INCOMING
MESSAGE LENGTH
Slide
to
or
INCOMING
1
5 MINUTES
the length of incoming messages.

CHECKING AN OGM

Follow these steps to check any OGM at any
time.
1. Slide
ANNOUNCE SELECT
to select the desired OGM.
2. Press
to play the OGM.
ANNOUNCE
8
until you hear a
SETTING THE NUMBER OF
RINGS
The ring select switch on the right side of the
TAD controls how long the TAD waits before
it answers a call. Slide the switch to the ap-
propriate position.
2 — The TAD answers after two rings.
to stop recording.
4 — The TAD answers after four rings.
7 — The TAD answers after seven rings.
TS
the TAD answers after two rings. Otherwise,
the TAD answers after four rings. This lets
you avoid unnecessary charges when calling
by long-distance to check your messages. If
you hear more than two rings, you know you
can hang up because the TAD has no new
messages.
to restrict
to
or
1, 2,
AO
Preparation
3. To stop the outgoing message before it
ends, press
.
STOP
— If there are new messages,
(Toll Saver)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents