Remote Operation; Changing The Remote Operation Security Code; Operating The Tad Froma Remote Location - Radio Shack TAD-723 Owner's Manual

43-723.fm Page 11 Monday, May 22, 2000 10:26 AM
shows 0 and the MESSAGE indicator light
turns off.
ˆ

Remote Operation

While you are away from your home or of-
fice, you can use a touch-tone phone or a
pulse (rotary) phone with a pocket tone dialer
to enter your remote operation security code
and do any of the following:
• set the TAD to answer calls
• listen to your messages
• record a new OGM
• record a memo
• delete individual or all messages
• change the security code
• turn on the room monitor
CHANGING THE REMOTE
OPERATION SECURITY
CODE
To use your TAD from a remote telephone,
you must first enter a 3-digit remote opera-
tion security code. The security code for your
TAD is preset to 500. Use the preset code, or
follow these steps to change it.
Note: Steps 2 and 3 require you to enter
your digit selection within 8 seconds. Other-
wise, the TAD beeps once and exits setup.
Start again at Step 1 if this happens.
1. Hold down
CODE/STOP
shows the code's first digit and the TAD
announces, "first digit."
Note: If you press
of all messages, the TAD beeps three times.
You cannot delete all messages until you
play back all new messages.
2. Press
desired digit.
3. Press
digit. The second digit appears and the
TAD announces, "second digit".
4. Repeat Steps 2 and 3 to set the second
and third digits of the security code.
5. After you press
third digit, TAD announces your security
code by saying, "Code is ---".
To check your security code, press
STOP
OPERATING THE TAD FROM
A REMOTE LOCATION
1. Dial your phone number. Even if the
TAD is not set to answer calls, it will
answer after about 10 rings.
2. After the outgoing message plays and
the TAD beeps, enter your remote oper-
ation security code.
Note: If you pause for 8 seconds
between digits, the TAD hangs up.
3. Enter
"Remote Commands" on Page 12).
4. When you finish, press
. The display access.
Remote Operation
before playback
DELETE
or
SKIP REPEAT
to store the selected
CODE/STOP
CODE/STOP
.
the remote command
to select the
to store the
CODE/
(see
to end remote
11