Remote Operation; Using Remote Commands; Using The Toll-Saver - Radio Shack TAD-704 Owner's Manual

43-704.fm Page 15 Wednesday, November 17, 1999 4:47 PM
1. Hold down
STOP
beeps once.
2. Press
CALLBACK
and SECURITY
flashes.
3. Repeatedly press
first digit, then press
ond digit flashes.
4. Repeat Step 3 to set the second and
the third digits.
5. Press
CALLBACK
to return to the time display.

REMOTE OPERATION

You can operate the TAD from almost
any touch-tone phone, or from a rotary
phone using a pocket tone-dialer (avail-
able at your local RadioShack store).
USING REMOTE
COMMANDS
Follow these steps to operate the TAD
remotely.
1. Dial your phone number.
2. When the TAD answers, enter your
remote operation security code. The
TAD beeps once to confirm that you
entered the correct code.
Notes:
• If you do not enter each digit
within 8 seconds, the TAD hangs
up.
until the TAD
three times. 704
appear. 7
CODE
to set the
REPEAT
. The sec-
SKIP
then press
STOP
• If the TAD is not set to answer
calls, it answers after about 9
rings.
3. Enter a remote command.
4. When you finish, simply hang up.

USING THE TOLL-SAVER

If the ring select switch is set to TS (toll-
saver), the TAD-704 answers after two
rings if you have new messages. If there
are no new messages, the TAD answers
after four rings. This gives you time to
hang up before the TAD answers so you
can avoid unnecessary long-distance
charges. See "Setting the Number of
Rings" on Page 9.
15