Assembly - Pro-Form 385ex User Manual

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Note: The treadmill walking deck is coated with
high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the
walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there
is lubricant on top of the walking belt, wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
During assembly, refer to the drawings
at the right to identify the small parts
used in assembly.
Assembly requires a phillips screw-
driver , an adjustable
wrench , and scissors
(not included), as well as the included
allen wrench .
1. With the help of a second person, carefully lay the
treadmill on its right side as shown (refer to the drawing
on page 4 to identify the right side).
Insert the Extension Legs (41) into the treadmill. Make
sure that the Extension Legs are turned so the Base
Pads (36) are on the indicated side. Attach each
Extension Leg with an Extension Leg Screw (34).
With the help of a second person, carefully raise the
treadmill to the upright position so the Extension Legs
(41) are resting flat on the floor.
Refer to the inset drawing. Remove the nut, bolt, and
shipping bracket from the left Upright (14) and discard.
2. Refer to HOW TO LOWER THE TREADMILL FOR USE
on page 11. Follow the instructions in step 2 to lower the
treadmill.
Cut the plastic ties that hold the cage nuts in each
Handrail (2).
Position one of the Handrails (2) on the left Upright (14).
The lower end of the Left Handrail should be resting
against the bracket on the Extension Leg (41) as shown.
Thread a Handrail Bolt (15) with a Handrail Washer (16)
into the left Upright and Handrail. Do not tighten the
Handrail Bolt yet.
Make sure that the hole in the bracket on the Extension
Leg (41) is aligned with the hole in the Handrail (2).
Tighten an Extension Leg Screw (34) into the bracket and
Handrail.
Washer (16)Ð2
3/4" Screw (59)Ð4
Handrail Bolt (15)Ð2
1
41
36
36
2
5
1/2" Screw (13)Ð2
Extension Leg Screw (34)Ð4
34
Shipping
Bracket
41
Nut
34
15
16
14
34
Bracket
41
Bolt
14
Plastic Tie
2