Rear Panel - TP-Link TL-R480T+ Installation Manual

Interface Description
Interface Description
The WAN port is designed to connect the Router to the interface provided
WAN
by ISP via the RJ45 cable
The LAN port is designed to connect the Router to the local PCs or
LAN
switches by the RJ45 cable
The Console port is designed to connect with the serial port of a computer
Console or terminal to check and monitor some simple system information of the
Router
Reset
With the Router powered on, use a pin to press and hold the Reset button (about 5
Router rebooting to its factory default settings.

Rear Panel

The rear panel of TL-R480T+ is shown as the following figure.
Power Socket
Connect the female connector of the power cord here, and the male connector to
the AC power outlet. Please make sure the voltage of the power supply meets the
requirement of the input voltage.
Grounding Terminal
The Router already comes with lightning protection mechanism. You can also ground
the Router through the PE (Protecting Earth) cable of AC cord or with Ground Cable.
For detailed information, please refer to Chapter 3 Lightning Protection.
Caution: Please use the provided power cord.
Figure 1-2 Rear Panel