Storing Text Tags; Assigning A Text Tag To A Channel - Radio Shack PRO-92 Owner's Manual

20-522b.fm Page 31 Thursday, September 7, 2000 9:41 AM
Notes:
• If you made a mistake in Step 3,
Freq briefly appears and the scanner beeps
when you press
ENTER
• Your scanner automatically rounds the entered
frequency to the nearest valid frequency. For
example, if you enter a frequency of 151.473,
your scanner accepts it as 151.470.
• Press then
FUNC
tion on or off. To have the scanner pause for 2
seconds on this channel after a transmission
before proceeding to the next active transmis-
sion, see "Using the Delay Function" on Page 40.
The scanner stores this setting in the channel.
• If you are storing frequencies for an EDACS sys-
tem, you must store them in logical channel num-
ber order, with the first frequency in channel 1 for
the current bank.
5. If necessary, press
mode. If you select
DPL code by pressing
the codes) or
FUNC
through the codes).
6. If desired, program a text tag for the channel (see

"Assigning a Text Tag to a Channel").

7. The next channel in sequence is ready for program-
ming. Press and then repeat Steps 3 through
PGM
5.

STORING TEXT TAGS

You can customize your scanner by storing text tags (up
to 12 characters) for easy identification of channel trans-
missions, trunk IDs, or banks.
Assigning a Text Tag to a Channel
1. Press , enter the channel number where
MANUAL
you want to enter the text, then press
again. M and the channel number appear at the
upper left corner of the display (for example:
Invalid
. Start again from Step 3.
to turn the delay func-
DELAY/1
to change the receiving
MODE
P/L or DPL , enter the PL or
(to move up through
STEP
then (to move down
STEP
MANUAL
Operation
M100 ).
31