Additional Information Troubleshooting - RCA Professional Series Owner's Manual

Additional Information
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there
is something wrong with this component, check the points below. Sometimes the trouble
may lie in another component. Investigate the other components and electrical appliances
being used. If the trouble cannot be resolved by following the the suggested remedies below,
take the unit to your nearest local RadioShack store.
This receiver has been manufactured to the specifications of RadioShack and is covered by a
limited warranty from RadioShack. If your receiver is not operating as it should, take it to
your local RadioShack store or call 1-800-THE-SHACK for assistance.
Problem
The power does not turn on.
No sound is output when a
function is selected.
No image is output when a
function is selected.
Considerable noise in radio
broadcasts.
Broadcast stations cannot be
selected automatically.
42
Remedy
• Connect the power plug to the wall outlet.
• Disconnect the power plug from the outlet, and insert again.
• Make sure there are no loose strands of speaker wire touching
the rear panel. This could cause the receiver to shut off automati-
cally.
• Make sure the component is connected correctly (refer to pages
14–21).
• Press on the remote control to turn muting off.
MUTE
• Adjust the
MASTER VOLUME
• Press the button to turn monitoring off.
MONITOR
• Make sure the component is connected correctly (refer to pages
14–21).
• Select the correct component (use the
• Tune in the correct frequency.
• Connect the antenna (refer to pages 17–18).
• Route 2
and digital cables away from any other terminals
RF
and wires.
• Fully extend the FM wire antenna, position for best reception,
and secure to a wall.
• Connect an outdoor FM antenna (refer to page 18).
• Adjust the direction and position for best reception.
• Connect an additional internal or external AM antenna (refer to
pages 17–18).
• Turn off the equipment causing the noise or move it away from
the receiver.
• Place the antenna farther away from the equipment causing the
noise.
Connect an outdoor antenna (refer to page 18).
( on the front panel).
VOLUME
dial).
MULTI JOG