RCA Professional Series Owner's Manual page 43

Problem
No sound from surround or center
speakers.
Noise during playback of a cassette
deck.
Sound is produced from other
components, but not from LD or
DVD player.
No sound is output or a noise is
output when software with DTS is
played back.
When a search is performed by a
DTS compatible CD player during
playback, noise is output.
Cannot operate the remote control.
The display is dark or off.
Note:
If the unit does not operate normally due to external effects such as static electricity
disconnect the power plug from the outlet and insert again to return to normal operating
conditions.
Remedy
• Refer to "Speaker Setting" on page 34 to check the speaker
settings.
• Refer to "Setting the Relative Volume Level of Each Channel" on
page 37 to check the speaker levels.
• Connect the speakers properly (refer to pages 19–20).
Move the cassette deck further from your receiver, until the noise
disappears.
• Set the
SIGNAL SELECT
according to the type of connections made. (refer to page 29).
• Set the digital input settings correctly (refer to page 36).
• Make digital connections (refer to page 15) and set the
to (refer to page 29).
SELECT DIGITAL
• Refer to the instruction manual supplied with the DVD player.
• Set the digital volume level of the player to full, or to the
neutral position.
• Refer to the manual supplied with the DVD player.
This is not a malfunction, but be sure to turn the volume down
to prevent the output of loud noise from your speakers.
• Replace the batteries (refer to page 7).
• Operate within 23 feet ( 7 m), 30° of the remote sensor on the
front panel (refer to page 8).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct
light.
Press on the remote control repeatedly to return to
FL DIMMER
the default.
Additional Information
to , or
AUTO DIGITAL ANALOG
SIGNAL
43