Char-Broil 463270512 Product Manual page 19

11
Insert front brace under control panel and between cart side panels. Make sure door hinge pins are on the top side and
facing the front. Secure using two 1/4-20x1½" screws, 7mm lock washers, and 7mm flat washers on each side.
NOTE: MAKE SURE THAT THE FRONT BRACE IS MOUNTED IN THE MOST DOWNWARD POSITION WHEN
ASSEMBLED TO CART.
12
Insert left and right grease tray rails into slots
Attach right and
Secure tank heat shield using two #8x3/8" self-tapping screws on each side panel.
A
Grease tray opening
Right rail
#8x3/8"
Left rail
self-tapping screw
Front brace
left rails under front brace with two #8x3/8" self-tapping screws, shown B.
Left rail
B
Right rail
NOTE: Wires must be left outside when installing tank heat shield.
beneath grease tray opening in upper back panel, shown A.
Tank heat shield
(Concave side up)
Tank heat shield
Door
Hinge Pin
7mm flat 7mm lock
washer washer
Wire
Meijer.com
1/4-20x1½"
screw
self-tapping
#8x3/8"
screw
19