Edimax BR-6258n User Manual page 62

ESSID
Channel Number
Associated Clients
Root AP SSID
Site Survey
Wireless Module
Click "Apply" to save the changes, or click "Cancel" to discard the changes. After you
have clicked "Apply", you will see the following message:
Click "Apply" to save the changes and restart the broadband router. It takes about 60
seconds for the broadband router to restart. Click "Continue" to configure other settings.
This is the name of your router. You can type any
alphanumerical character here (maximum 32
characters).
Select a channel from the dropdown menu. All access
points must use the same channel (1 to 13).
Click "Show Active Clients" for the list of all
connected wireless clients. Click "Refresh" in the
new window to renew the list, and click "Close" to
close the window.
Note: If you have a pop‐up blocker installed, you
may have to disable it, or set it to allow the pop‐up
window to show up.
Input the SSID of the wireless access point with
which you wish to connect.
Click "Select Site Survey" and a pop‐up window will
appear. All reachable wireless access points will be
shown in the window. Select a wireless access point
from the list, and click "Done" to establish a
connection. Clicking "Refresh" will renew the list.
Select "Enable" to turn on the 2.4GHz wireless
signal and select "Disable" to turn it off.
61