Remote Control Functions - Twin-Star International 35HF500GRA- OAK Homeowners Operating Manual

Wall hanging electric fireplace

Hide thumbs

Table Of Contents

Table of Contents

REMOTE CONTROL FEATURES WORK SEAMLESSLY WITH CONTROL PANEL FUNCTIONS

5 BUTTONS REMOTE

Models : 35HF500GRA -ESP /BLK/ OAK

NOTE: The fireplace Main Power Switch must be

switched ON in order for the Remote Control to function.

POWER

The Power button will put the fireplace in a standby

mode. This will turn off all functions at once but

will hold the settings in memory. Except Heater function,

by pressing the button again the unit will turn on at the

same settings.

FLAME

The fireplace has four flame effects, by pressing the

FLAME button the unit will cycle through each effect.

BACK LIGHT

The fireplace has five back light effects, by pressing the

backlight button the unit will cycle throught each effect

it including OFF setting.

SPEED

Press SPEED button, the flame speed will be changed.

Total 3 speed levels.

HEATER

Press once turns left hand heater on. (Pilot lights

illuminated

●○)

Press again turns left hand heater off and right hand

. h eater on. (Pilot lights illuminated

Press third time turns left and right hand heater on. (Pilot lights illuminated

Press fourth time t urns left and right hand heater off. (Pilot lights illuminated

NOTE: This remote control uses 1 CR2032 Lithium lon button cell battery (Included). Never dispose of

batteries in ﬁre, except under conditions of controlled incineration. (Failure to observe this precaution may

result in an explosion.)

NOTE: This equipment has been tested and found to comply with the limits for Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio or television reception, which can be determined by turning the equipment off and on,

the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation.

Modifications not approved by the party responsible for compliance could void user's authority to

operate the equipment.

This Class B digital apparatus complies with Canadian ICES-003.