Remote Control Functions - Twin-Star International DFI016ARA Operating Manual

4 BUTTONS REMOTE
NOTE: The unit Main Power Switch must be turn on
in order for the Remote Control to function.
POWER
The Power button will put the insert in a standby mode.
This will turn off all functions at once but will hold the
settings in memory. By pressing the button again the unit
will turn on at the same settings.
FLAME
Each time this button is pressed, the intensity of the
flame decreases. There are six brightness levels you
can cycle through including the OFF setting.
HEAT
This button will turn the power to the heater and
blower on and off. when the heater is turned ON it
will take several seconds for the unit to begin blowing
hot air. The rotary switch (Temperature) controls the
thermostat feature to help regulate your room's
temperature accordingly.
PLAY/PAUSE
Note:
This button function just apply for ARU series
model.
Press this button you can control the undulating flame
effect to play or pause.
Notice: This remote control uses 2 PCS AAA batteries. Never dispose of batteries in fire, except under condition
controlled incineration. (Failure to observe this precaution may result in an explosion.)
The motors used on the fan and the flame generator assembly are pre-lubricated for extended bearing life and
require no further lubrication. However, periodic cleaning/vacuuming of the fan/heater unit is recommended.
Make sure the unit is turned OFF and unplugged whenever you are cleaning the heater or fireplace.
WARNING: Make sure the power is turned off before proceeding. Any electrical repairs or
rewiring of this unit should be carried out by a licensed electrician in accordance with
national and local codes.
If repairing or replacing any electrical component or wiring, the original wire routing, color
coding and securing locations must be followed.
WARNING: Electrical outlet wiring must comply with local building codes and other applicable
regulations to reduce the risk of fire, electrical shock and injury to persons.
WARNING: Do not use this fireplace if any part of it has been under water. Immediately call a
qualified service technician to inspect the fireplace and replace any part of the electrical system.
Warning: Disconnect power before attempting any maintenance or cleaning to reduce the risk
of fire, electrical shock or personal injury.
Warning: During any service of this appliance, the power to the unit must be turned off.
First turn the main power switch to the "OFF" position. Then remove the electrical plug from
the wall outlet.

REMOTE CONTROL FUNCTIONS

MAINTENANCE
MAINTENANCE
E-6
Fig. 4
Note: Please operate remote transmitter at a slow measured
pace. Depress the remote control buttons with an even motion
and gentle pressure. Repeatedly pressing buttons in rapid
succesion may cause the transmitter to malfunction.
Meijer.com