Wireless Speaker System - RCA DVD/CD Receiver Speaker System Owner's Manual

Additional Information
Problem
Sound is mono only.
Considerable noise in
radio broadcasts.

Wireless Speaker System

Problem
Audio is interrupted.
Audio is suddenly
interrupted.
Horizontal stripe noise
interference on a TV set
near the transmitter.
84
Remedy
Check that the tuner is not set to FM mono (see "Improving Poor
FM Reception" on page 39).
• Tune into the correct frequency.
• Connect the antenna (see "Connecting the Supplied Antennas"
on page 20 and "Connecting External Antennas" on page 78).
• Fully extend the FM wire antenna, position for best reception,
and secure to a wall.
• Connect an outdoor FM antenna (see "Connecting External
Antennas" on page 78).
• Adjust the direction and position for best reception.
• Connect an additional internal or external AM antenna (see "AM
Loop Antenna" on page 20 and "Connecting External Antennas"
on page 78).
• Turn off any other equipment that may be causing the noise or
move it away from the system unit.
• The tuning interval is incorrect for your country or region. Try
switching the tuning interval (frequency step) (see "Changing the
Frequency Step" on page 74).
Remedy
•This system uses high frequency radio waves that have properties
similar to light, such as linearity, reflection, refraction, diffraction,
and interference. Therefore, placement of the system can result in
weak radio waves and/or interruption.
•The distance between the transmitter and receiver may be too
large. Use the receiver within the reach of radio wave from the
transmitter.
•Is the system being used in a location with favorable condition
for electrical noise generation?
There may be radio communication equipment using the same
frequency band (2.4 GHz) as this system, such as a Bluetooth
device, radio LAN device or microwave oven, operating nearby.
•Is there a piece of A/V equipment with an antenna near the
transmitter? If so, move the transmitter away from the antenna
input terminal of the AV equipment.