Table of Contents
Advertisement
3. Connect the power adapter to the wall socket, and then connect it to the '5VDC' socket
on the back panel of the router.
4. Please check all the LEDs on the front panel. The 'PWR' LED should be steadily on, WAN
and LAN LEDs should be on if the computer / network device connected to the
respective port of the router is powered on and correctly connected. If PWD LED is not
on, or any LED you expected is not on, please recheck the cabling, or jump to '4‐2
Troubleshooting' for possible reasons and solution.
5. To improve wireless signal reception, please arrange the antenna and make it
perpendicular to the ground, and place the wireless access point in open space. Please
keep the distance between antennas, if the antennas are too close to each other,
wireless signal reception will be affected.
Advertisement
Table of Contents
