Preset Memory; Preset Tuning; Channel Scan; Direct Access Tuning - Kenwood KDC-BT742U Instruction Manual

~
~
• You cannot Channel search until the category
information is acquired.
Preset Memory
Putting the channel in the memory.
1
Select the channel to put in the memory
Push the [AUD] knob towards right or left.
2
Enter Preset Memory mode
Press the [SEARCH] button.
3
Select the number to put in the memory
Turn the [AUD] knob or push it towards up or
down.
4
Determine the number to put in the memory
Press the [AUD] knob for at least 1 second.
Cancelling the
Preset Memory mode
Press the [SEARCH] button.
~
~
• Only the channel number is stored. Category information
is not stored.
Preset Tuning
Recalling the channels in the memory.
1
Enter Preset Tuning Select mode
Press the [SEARCH] button.
2
Select a desired station in the memory
Turn the [AUD] knob or push it towards up or
down.
3
Recall the station
Press the [AUD] knob.
Cancelling Preset
Tuning
Press the [SEARCH] button.
Channel Scan
Every receivable Channel is checked for 10 seconds.
1
Start Channel Scan
Select
"CH-SCAN'~
For how to select Function Control items, refer to
<Function Control> (page 6).
2
Release it when the channel you want to listen
to is received
Press the [AUD] knob.
Function
of
remote control
Direct Access Tuning
Entering the channel and tuning.
1
Enter Direct Access Tuning mode
Press the [DIRECT] button on the remote
control.
2
Enter the channel
Press the number buttons.
3
Do Channel Search
Press the
[~]
or
[~]
button.
Cancelling
Direct
Access Tuning
Press the [DIRECT] button on the remote
control.
Q
~
If you make no button operation for 10 seconds, the
Direct Access Tuning mode is automatically canceled.
If you cannot receive any signal in the input Channel due
to bad conditions on radio wave or other such problems,
"ACQUIRING SIGNAL"/ "NO SIGNAL" appears.
English
I
33