Installation/Removing The Unit - Kenwood KDC-BT742U Instruction Manual

Installation/Removing the Unit
non-Japanese cars Removing the hard rubber frame
\
Bend the tabs of the mounting
sleeve with a screwdriver or similar
utensil and attach it in place.
Q
~
1
Engage the catch pins on the removal tool and
remove the two locks on the upper level.
Upper the frame and pull it forward as shown in
the figure.
Accessory0
Removal tool
Accessory0
1
Refer to the section <Removing the hard rubber
frame> and then remove the hard rubber frame.
2
Insert the two removal tools deeply into the slots
on each side, as shown.
3
Lower the removal tool toward the bottom, and
pullout the unit halfway while pressing towards
the inside.
Removing the Unit
~
~
• The frame can be removed from the bottom side in the
same manner.
2
When the upper level is removed, remove the
lower two locations.
rs
---'
T@
+-
@N
@ @
!T/N
N
T
" -
/1
T:
Toyota car
N: Nissan ca
!?
-=r
smm
MAX.
W
-=r&nm
MAX.
H @
~--j(!)
05mm
05mm
Accessory@ ...for Nissan car
Accessory@...forToyota car
Make sure that the unit is installed securely in place. If the
unit is unstable, it may malfunction (for example, the sound
may skip).
Japanese cars
1
Refer to the section <Removing the hard rubber
frame> and then remove the hard rubber frame.
2
Align the holes in the unit (two locations on each
side) with the vehicle mounting bracket and secure
the unit with the accessory screws.
.&.
CAUTION
Install this unit in the console of your vehicle.
Do not touch the metal part of this unit during and
shortly after the use of the unit. Metal part such as
the heat sink and enclosure become hot.
.&.
• Be careful to avoid injury from the catch pins on the
removal tool.
4
Pull the unit all the way out with your hands, being
careful not to drop it.
English
I
43