Edimax EW-7228APn User Manual page 44

MAIN SSID
Multiple ESSID
Channel Number
Associated Clients
Root AP SSID
Select Site Survey
you select (802.11b, 802.11 Draft-N, or 802.11g)
will be able to connect to this access point.
If you select 2.4GHz (B+G), then only wireless
clients using 802.11b and 802.11g band will be
able to connect to this access point.
If you want to allow 802.11b, 802.11g, and 802.11
Draft-N clients to connect to this access point,
select 2.4GHz (B+G+N).
Please input the ESSID (the name used to identify
this wireless access point) here. You can input up
to 32 alphanumerical characters. PLEASE NOTE
THAT ESSID IS CASE SENSITIVE.
The access point supports multiple SSID function;
up to four SSIDs can be set. If you want to
configure additional SSIDs, please click this
button. For detailed descriptions of the function,
please refer to Section 2-4-1-1.
Please select a channel number you wish to use.
The channel number must be same with another
wireless access point you wish to connect
Click „Show Active Clients‟ button and a new
popup window will appear which contains the
information about all wireless clients connected to
this access point. You can click „Refresh‟ button in
popup window to keep information up-to-date
In „Universal Repeater‟ mode, this device can act
as a station to connect to a Root AP. You should
assign the SSID of the Root AP here or click
„Select Site Survey‟ button to choose a Root AP.
Click „Select Site Survey‟ button, then a "Wireless
Site Survey Table" will pop up. It will list all
available access points near by. You can select one
access point in the table and the access point will
join wireless LAN through this access point. Please
go to Section 2-4-2-1 for more information about
the „Wireless Site Survey Table‟.
37