both wireless access points will be connected together. You can use this
mode to connect a network to another network which is physically
isolated.
Please note that when you set your access point to this mode, it will not
accept regular wireless clients anymore.
When you select „AP Bridge-Point to Point‟, the following options will
be displayed:
Here are descriptions of every setup item:
Band
Channel Number
Please select the wireless band you wish to use. By
selecting different band setting, you‟ll be able to
allow or deny the wireless client of a certain band.
If you select 2.4GHz (B), 2.4GHz (N), or 2.4GHz
(G), only wireless clients using the wireless band
you select (802.11b, 802.11 Draft-N, or 802.11g)
will be able to connect to this access point.
If you select 2.4GHz (B+G), then only wireless
clients using 802.11b and 802.11g band will be
able to connect to this access point.
If you want to allow 802.11b, 802.11g, and 802.11
Draft-N clients to connect to this access point,
select 2.4GHz (B+G+N).
Please select a channel number you wish to use.
30