Docking Connecter Board - HP Split 13 x 2 PC Maintenance And Service Manual

2. Release the vibrator module (2) from the clip molded into the display assembly.
3. Remove the vibrator module and cable.
Reverse this procedure to install the vibrator module.

Docking connecter board

Description
Docking connecting board
NOTE: The docking connector board does not include the docking connector board cables. The
docking connector board cables are included in the Cable Kit, spare part number 736883-001.
See Cable Kit on page 21
Before removing the docking connector board, follow these steps:
1.
Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2. Disconnect the power from the tablet by unplugging the power cord from the tablet.
3. Disconnect all external devices from the tablet.
4. Remove the back cover (see
5. Remove the tablet battery (see
for more Cable Kit spare part information.
Back cover on page
Tablet battery on page
34).
36).
Removal and replacement procedures
Spare part number
736888-001
53