Dhcp Server Settings - D-Link AC1750 User Manual

Section 3 - Configuration
DHCP stands for Dynamic Host Control Protocol. The DIR-868L has a built-in DHCP server. The DHCP Server will automatically
assign an IP address to the computers on the LAN/private network. Be sure to set your computers to be DHCP clients by setting
their TCP/IP settings to "Obtain an IP Address Automatically. " When you turn your computers on, they will automatically load
the proper TCP/IP settings provided by the DIR-868L. The DHCP Server will automatically allocate an unused IP address from
the IP address pool to the requesting computer. You must specify the starting and ending address of the IP address pool.
Check this box to enable the DHCP server on your router.
Enable DHCP
Uncheck to disable this function.
Server:
DHCP IP Address
Enter the starting and ending IP addresses for the DHCP server's
Range:
IP assignment.
Note: If you statically (manually) assign IP addresses to your
computers or devices, make sure the IP addresses are outside of
this range or you may have an IP conflict.
DHCP Lease Time:
The length of time for the IP address lease. Enter the Lease time
in minutes.
Always
Enable this feature to broadcast your networks DHCP server to
Broadcast:
LAN/WLAN clients.
NetBIOS
NetBIOS allows LAN hosts to discover all other computers within
Announcement:
the network, enable this feature to allow the DHCP Server to
offer NetBIOS configuration settings.
Learn NetBIOS
Enable this feature to allow WINS information to be learned from the WAN side, disable to allow manual configuration.
from WAN:
NetBIOS Scope:
This feature allows the configuration of a NetBIOS 'domain' name under which network hosts operates. This setting has no effect if
the 'Learn NetBIOS information from WAN' is activated.
D-Link DIR-868L User Manual

DHCP Server Settings

53