IBM System x3550 M4 Installation And User Manual page 52

The following table describes the functions of the SW3 switch block on the system
board.
Important:
1. Before you change any switch settings or move any jumpers, turn off the server;
2. Any system-board switch or jumper block that is not shown in the illustrations in
36
IBM System x3550 M4 Type 7914: Installation and User's Guide
Table 5. System board SW3 switch block definition
Switch
number Default position
1 Off
2 Off
3 Off
4 Off
then, disconnect all power cords and external cables. Review the information in
vii, "Installation guidelines" on page 38, "Handling static-sensitive devices" on
page 40, and "Turning off the server" on page 28.
this document are reserved.
Description
Reserved.
Reserved.
Reserved.
Power-on password override. Changing the position
of this switch bypasses the power-on password
check the next time the server is turned on and
starts the Setup utility so that you can change or
delete the power-on password. You do not have to
move the switch back to the default position after
the power-on password in overridden.
Changing the position of this switch does not affect
the administrator password check if an administrator
password is set.
See "Passwords" on page 113 for additional
information about passwords.