IBM System x3250 M3 Type 4251 Installation And User Manual page 75

Select this choice to enter the System Event Manager, where you can view the
POST event log and system-event log.
The POST event log contains the three most recent error codes and messages
that were generated during POST.
The system-event log contains POST and system management interrupt (SMI)
events and all events that are generated by the baseboard management
controller that is embedded in the integrated management module.
Important: If the system-error LED on the front of the server is lit but there are
no other error indications, clear the system-event log. Also, after you complete a
repair or correct an error, clear the system-event log to turn off the system-error
LED on the front of the server.
– POST Event Viewer
Select this choice to enter the POST event viewer to view the POST event
log.
– System Event Log
Select this choice to view the system-event log.
– Clear System Event Log
Select this choice to clear the system-event log.
v User Security
Select this choice to set or clear passwords. See "Passwords" on page 62 for
more information.
This choice is on the full and limited Setup utility menu.
– Power-on Password
Select this choice to set a power-on password. See "Power-on password" on
page 62 for more information.
– Administrator Password
Select this choice to set an administrator password. An administrator
password is intended to be used by a system administrator; it limits access to
the full Setup utility menu. If an administrator password is set, the full Setup
utility menu is available only if you type the administrator password at the
password prompt. For more information, see "Administrator password" on
page 63.
Attention: If you forget the administrator password, you cannot reset the
password. You must replace the system board.
v Save Settings
Select this choice to save the changes that you have made in the settings.
v Restore Settings
Select this choice to cancel the changes that you have made in the settings and
restore the previous settings.
v Load Default Settings
Select this choice to cancel the changes that you have made in the settings and
restore the factory settings.
v Exit Setup
Select this choice to exit from the Setup utility. If you have not saved the
changes that you have made in the settings, you are asked whether you want to
save the changes or exit without saving them.
Chapter 3. Configuring the server
61