IBM System x3250 M3 Type 4251 Installation And User Manual page 56

v The optional ServeRAID-MR10i adapter can be purchased and supports RAID
v To ensure that any of your ServeRAID adapters function properly on UEFI-based
v The server scans the PCI slots to assign system resources. The scan sequence
v A PCI Express riser-card assembly has a black connector and supports PCI
To install an adapter, complete the following steps:
42
IBM System x3250 M3 Types 4251, 4252, and 4261: Installation and User's Guide
levels 0, 1, 5, 6, and 10. The optional ServeRAID-MR10is VAULT adapter with an
encryption 1078 DE chip set can be purchased and supports RAID levels 0, 1, 5,
6, and 10. For configuration information, see the ServeRAID documentation at
http://www.ibm.com/systems/support/.
Attention: To ensure proper cooling and airflow, install a ServeRAID adapter
that has a battery attached in slot 2 on the riser-card assembly.
servers, make sure that the adapter firmware level and supporting device drivers
are updated to at least 11.x.x-XXX.
is related to the startup sequence. If you have not changed the default startup
sequence, the server scans the PCI slots in the following order: the integrated
Ethernet controllers 1 and 2; then, the drives that are connected to the
SAS/SATA controller; then, PCI Express slots 1 and 2.
Express adapters, and a PCI-X riser-card assembly has a white (light in color)
connector and supports PCI-X adapters.
Adapter
Riser-card
assembly
1. Read the safety information that begins on page v and the "Installation
guidelines" on page 26.
2. Turn off the server and peripheral devices and disconnect the power cords and
all external cables; then, remove the server cover (see "Removing the cover"
on page 28).
3. Grasp the riser-card assembly at the front grip point and rear edges; then, lift
to remove the riser-card assembly. Place the riser-card assembly on a flat,
static-protective surface.
Expansion-slot cover
Expansion slot 2
Expansion slot 1
Expansion-slot cover
Adapter
Guide channels