IBM System x3250 M3 Type 4251 Installation And User Manual page 74

v Date and Time
v Start Options
v Boot Manager
v System Event Logs
60
IBM System x3250 M3 Types 4251, 4252, and 4261: Installation and User's Guide
Select this choice to view or enable the POST watchdog timer.
- POST Watchdog Timer Value
Select this choice to view or set the POST loader watchdog timer value.
- Reboot System on NMI
Enable or disable restarting the system whenever a nonmaskable interrupt
(NMI) occurs. Enable is the default.
- Commands on USB Interface Preference
Select this choice to enable or disable the Ethernet over USB interface on
IMM.
- Network Configuration
Select this choice to view the system management network interface port,
the IMM MAC address, the current IMM IP address, and the host name;
define the static IMM IP address, subnet mask, and gateway address;
specify whether to use the static IP address or have DHCP assign the IMM
IP address; save the network changes; and reset the IMM.
- Reset IMM to Defaults
Select this choice to view or reset IMM to the default settings.
- Reset IMM
Select this choice to reset IMM.
– System Security
Select this choice to view or configure Trusted Platform Module (TPM)
support.
– Adapters and UEFI Drivers
Select this choice to view information about the UEFI 1.10 and UEFI 2.0
compliant adapters and drivers installed in the server.
– Network
Select this choice to view or configure the network device options, such as
PXE and network devices.
Select this choice to set the date and time in the server, in 24-hour format
(hour:minute:second).
This choice is on the full Setup utility menu only.
Select this choice to view or boot to devices, including the startup sequence. The
server starts from the first boot record that it finds.
The startup sequence specifies the order in which the server checks devices to
find a boot record. The server starts from the first boot record that it finds.
This choice is on the full Setup utility menu only.
Select this choice to view, add, delete, or change the device boot priority, boot
from a file, select a one-time boot, or reset the boot order to the default setting.
If the server has Wake on LAN hardware and software and the operating system
supports Wake on LAN functions, you can specify a startup sequence for the
Wake on LAN functions. For example, you can define a startup sequence that
checks for a disc in the CD-RW/DVD drive, then checks the hard disk drive, and
then checks a network adapter.