Power Connections - Cisco 1900 series Hardware Installation

Power Connections

Power Connections
Read the installation instructions before connecting the system to the power source. Statement 1004.
Warning
The installation must comply with all required electrical codes applicable at the installation site.
Note
Connect your router to a 15 A, 120 VAC (10 A, 240 VAC) circuit with over current protection.
The input voltage tolerance limits for AC power are 85 and 264 VAC.
Note
Warning This product relies on the building's installation for short-circuit (over current) protection. Ensure that
the protective device is rated not greater than: 15A, 120VAC (10A, 240VAC). Statement 1005
Warning Take care when connecting units to the supply circuit so that wiring is not overloaded. Statement 1018
This section explains how to connect AC or DC power to Cisco 1900 series routers and a console
terminal. It covers the following topics:
•
•
•
For cable information and specifications, see the
To see translations of the warnings that appear in this publication, refer to the
Note
and Safety Information for Cisco 1900 Series Routers
Cisco 1900 Series Hardware Installation
4-12
Power Connections, page 4-12
Connecting WAN and LAN Cables, page 4-13
Connecting to a Console Terminal or Modem, page 4-16
Chapter 4 Installing and Connecting the Router
"Network Cabling Specifications"
document.
section.
Regulatory Compliance
OL-19084-02