Cisco 1900 series Hardware Installation page 60

Wall-Mounting the Chassis
Figure 4-4
Figure 4-4
1
Wall screws
3 Chassis mounting holes (on bottom)
5 Mounting surface
To mount the router on a wall or other surface, follow these steps:
Install the two screws 5.00 inches (12.7 centimeters) horizontally apart on a wall or other vertical
Step 1
surface.
The screws should protrude 0.25 inch (0.6 centimeter) from the surface of the wall.
Remove the rubber feet from the router.
Step 2
Hang the router on the screws. This is the appropriate orientation for safe use. (See
Step 3
Figure
If you install the screws in drywall, use hollow-wall anchors (1/8 inch by 5/16 inch) to secure the
Caution
screws. If the screws are not properly anchored, the strain of the cables connected to the router back
panel could pull the router from the wall.
Cisco 1900 Series Hardware Installation
4-6
shows the wall-mounting features on the Cisco 1941 series routers.
Wall-Mounting Features on the Cisco 1941 Router
1
2
4-4.)
Chapter 4 Installing and Connecting the Router
5
4
3
2
5 inches (12.7 cm)
4 Router chassis
Figure 4-3 and
OL-19084-02