Chassis Security; Wireless Lan Connectivity - Cisco 1900 series Hardware Installation

Chapter 1 Overview of the Router
If the lithium battery in a Cisco 1900 ISR should fail, the router must be returned to Cisco for repair.
Note
Although the battery is not intended to be field-replaceable, the following warning must be heeded:
Dispose of used batteries according to the manufacturer's instructions. Statement 1015
Warning

Chassis Security

The chassis of the router is constructed with a Kensington
secured to a desktop or other surface by using Kensington

Wireless LAN Connectivity

The embedded Wi-Fi CERTIFIED™, 802.11a/b/g/n-compliant wireless access point is preinstalled in
the router as an optional feature. The Cisco 1900 series routers support both autonomous and unified
features and network configurations.
The wireless access point does not have an external console port for connections. To configure the
wireless device, you must use a console cable to connect a PC to the host router's console port as
described in
command-line interface (CLI) to access the interface.
Table 1-5
The 5-GHz radio incorporates an Unlicensed National Information Infrastructure (UNII) radio
transceiver operating in the UNII 1, 2, 3, 5-GHz frequency bands.
Table 1-5
Radio Module
Dual-band
802.11a/b/g/n
radio module
1. Actual data rate is highly dependent on your wireless environment.
2. The antennas require some minor installation. They must be screwed onto the RP-TNC antenna connectors on the I/O side of
OL-19084-02
Chapter 5, "Connecting to a Console Terminal or Modem,"
describes the radios and antennas for the Cisco 1900 series wireless routers.
Wireless Device Radios and Antennas
Platform
Cisco 1900
series
wireless
routers
the chassis. See the following document on Cisco.com for feature information:
http://cisco.com/en/US/products/ps5853/prod_installation_guide09186a00804399cd.html
TM
TM
Radio Maximum Data
1
Band Throughput
2.4 GHz 100 Mb/s per
and 5 radio, up to 200
GHz Mb/s total
Cisco 1900 Series Hardware Installation
Hardware Features
security slot on the back panel. It can be
lockdown equipment.
and then use the Cisco IOS
Mode Antenna
Autonomous Three dual-band
and unified removable
2.4-GHz/5-GHz
omnidirectional
dipole RP-TNC
antennas
2
1-13