Lenovo ThinkCentre Hardware Maintenance Manual page 76

70
Hardware Maintenance Manual
Diagnostic Error Code
086-197-XXX
Mouse Port interface test warning
086-198-XXX
Mouse Port interface test aborted
086-199-XXX
Mouse Port interface test failed, cause
unknown
089-000-XXX
Microprocessor Test Passed
089-XXX-XXX
Microprocessor failure
089-195-XXX
Microprocessor Test aborted by user
089-196-XXX
Microprocessor test halt, error threshold
exceeded
089-197-XXX
Microprocessor test warning
089-198-XXX
Microprocessor test aborted
089-199-XXX
Microprocessor test failed, cause unknown
170-000-XXX
Voltage Sensor(s) Test Passed
FRU/Action
1. Make sure the component that is called
out is connected and/or enabled. See
Chapter 6, "Using the Setup Utility," on
page 49
2. Re-run test
3. Replace the component that is called out
in warning statement
4. Replace the component under test
1. If a component is called out, make sure
it is connected and/or enabled. See
Chapter 6, "Using the Setup Utility," on
page 49
2. Flash the system and re-test. See "Flash
update procedures" on page 533
3. Go to "Undetermined problems" on page
79
1. See "Undetermined problems" on page
79
2. Flash the system and re-test. See "Flash
update procedures" on page 533
3. Replace component under function test
No action
1. Microprocessor(s)
2. System board
Information only
Restart the test, if necessary
1. Press F3 to review the log file
2. Restart the test to reset the log file
1. Make sure the component that is called
out is connected and/or enabled. See
Chapter 6, "Using the Setup Utility," on
page 49
2. Re-run test
3. Replace the component that is called out
in warning statement
4. Replace the component under test
1. Flash the system. See "Flash update
procedures" on page 533
2. Go to "Undetermined problems" on page
79
1. See "Undetermined problems" on page
79
2. Flash the system and re-test. See "Flash
update procedures" on page 533
3. Replace component under function test
No action