Replacing A Memory Module - Lenovo ThinkCentre Hardware Maintenance Manual

Replacing a memory module

This provides instructions on how to remove and replace a memory module.
1. Remove the computer cover. See "Removing the computer cover" on page 85.
2. Locate the memory module connectors. See "System board connectors" on page
3. Open the retaining clips.
4. Position the new memory module over the memory slot. Make sure that the
Attention
Do not open your computer or attempt any repair before reading and understanding the
"Important safety information" in the ThinkCentre Safety and Warranty Guide that came with
your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
Note: For this procedure, it helps to lay the computer on its side.
84.
If you are replacing an old memory module, open the retaining clips and
remove the memory module being replaced as shown.
notch 1 on the memory module aligns correctly with the slot key 2 on the
system board. Push the memory module straight down into the slot until the
retaining clips close.
Chapter 8. Replacing FRUs - Tamdhu Computers
99