Replacing The Front Audio/Usb Assembly - Lenovo ThinkCentre Hardware Maintenance Manual

Replacing the front audio/USB assembly

This section provides instructions on how to remove and replace the front
audio/USB assembly.
10. Go to "Completing the FRU replacement" on page 121.
Attention
Do not open your computer or attempt any repair before reading and understanding the
"Important safety information" in the ThinkCentre Safety and Warranty Guide that came with
your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
1. Remove the computer cover. See "Removing the computer cover" on page 85.
2. Remove the front bezel. See "Removing and installing the front bezel" on
page 87
3. Disconnect the front audio/USB assembly cable from the system board. See
the system board illustration for your machine type at "System board
connectors" on page 84.
4. Note the front audio/USB assembly cable routing and remove the screw that
secures the assembly to the chassis.
5. Remove the front audio/USB assembly.
6. Route the cable for the new front audio/USB assembly through the hole in the
chassis and to the system board.
7. Install the front audio/USB assembly into the chassis and secure it with the
screw.
8. Connect the front audio/USB assembly cable to the system board.
9. Reinstall the front bezel.
Chapter 8. Replacing FRUs - Tamdhu Computers
117