Lenovo ThinkCentre Hardware Maintenance Manual page 69

Diagnostic Error Code
015-036-XXX
USB port Register error
015-040-XXX
USB port IRQ failure
015-195-XXX
USB port Test aborted by user
015-196-XXX
USB port test halt, error threshold exceeded
015-197-XXX
USB port test warning
015-198-XXX
USB port test aborted
015-199-XXX
USB port test failed, cause unknown
018-000-XXX
PCI Card Test Passed
018-0XX-XXX
PCI Card Failure
018-195-XXX
PCI Card Test aborted by user
018-196-XXX
PCI Card test halt, error threshold exceeded
FRU/Action
System board
1. Run setup and check for conflicts
2. Flash the system. See "Flash update
procedures" on page 533
3. System board
Information only
Restart the test, if necessary
1. Press F3 to review the log file
2. Restart the test to reset the log file
1. Make sure the component that is called
out is connected and/or enabled. See
Chapter 6, "Using the Setup Utility," on
page 49
2. Re-run test
3. Replace the component that is called out
in warning statement
4. Replace the component under test
1. If a component is called out, make sure
it is connected and/or enabled. See
Chapter 6, "Using the Setup Utility," on
page 49
2. Flash the system and re-test. See "Flash
update procedures" on page 533
3. Go to "Undetermined problems" on page
79
1. Go to "Undetermined problems" on page
79
2. Flash the system and re-test. See "Flash
update procedures" on page 533
3. Replace component under function test
No action
1. Riser card, if installed
2. System board
1. PCI card
2. Information only
Restart the test, if necessary
1. Press F3 to review the log file
2. Restart the test to reset the log file
Chapter 7. Symptom-to-FRU Index
63