Bbwc Module And Battery Pack Option - HP ProLiant DL120 G7 User Manual

Install the storage controller.
6.
Connect the storage controller cable to the controller and to the drive backplane.
7.
See the server installation sheet and the documentation that ships with the storage controller.
IMPORTANT:
properly.
Install the PCIe riser cage (on page 19).
8.
Install the access panel (on page 18).
9.
Install the server into the rack
10.
Power up the server (on page 17).
11.

BBWC module and battery pack option

CAUTION:
the battery pack while an array capacity expansion, RAID level migration, or stripe size migration
is in progress.
CAUTION:
before unplugging the cable from the cache module. If the amber LED blinks after 15 seconds, do
not remove the cable from the cache module. The cache module is backing up data, and data is
lost if the cable is detached.
IMPORTANT:
error message is displayed when the server is powered up, indicating that the battery pack is
temporarily disabled. No action is necessary on your part. The internal circuitry automatically
recharges the batteries and enables the battery pack. This process might take up to four hours.
During this time, the cache module functions properly, but without the performance advantage of
the battery pack.
NOTE:
is restored to the system, an initialization process writes the preserved data to the hard drives.
To install the component:
Power down the server (on page 17).
1.
Remove the server from the rack (on page 17).
2.
Remove the access panel (on page 18).
3.
Remove the PCIe riser cage (on page 18).
4.
Install the storage controller, if not installed
5.
The server does not power up if the PCI riser board assembly is not seated
("Installing the server into the
To prevent a server malfunction or damage to the equipment, do not add or remove
After the server is powered down, wait 15 seconds and then check the amber LED
The battery pack might have a low charge when installed. In this case, a POST
The data protection and the time limit also apply if a power outage occurs. When power
rack" on page 25).
("Storage controller option" on page 37).
Hardware options installation 38