Horizon Fitness H-SERIES E5 User Manual page 6

AS SE MB LY ST EP 
A) Open HARDWARE BAG FOR STEP 4.
B) Attach the PEDAL ARM COVER using 1 SCREW (J).
C) Attach the ROLLER WHEEL COVER using 1 SCREW (K).
D) Repeat on other side.
HARDWARE BAG FOR STEP  CONTENTS :
10
H-series_E5_Rev.1.2.indd 10-11
PEDAL ARM
PEDAL ARM COVER
SCREW (J)
SCREW (K)
ROLLER WHEEL COVER
SCREW (J) SCREW (K)
15 mm 12 mm
Qty: 2 Qty: 2
ASSEMBLY STEP 5
CONSOLE MAST
CONSOLE MAST
PRE-ATTACHED BOLTS
AND WASHERS
PRE-ATTACHED BOLTS
AND WASHERS
LOWER HANDLEBAR
LOWER HANDLEBAR
NOTE: There is NO hardware bag for this step. All hardware is pre-attached.
A) Remove PRE-ATTACHED BOLTS and WASHERS from CONSOLE MAST.
B) Slide right LOWER HANDLEBAR on CONSOLE MAST and attach by reinserting PRE-ATTACHED BOLT and WASHERS.
C) Remove PRE-ATTACHED SET SCREWS from right UPPER HANDLEBAR
D) Slide right UPPER HANDLEBAR onto LOWER HANDLEBAR and secure by reinserting PRE-ATTACHED SET SCREWS
E) Repeat on other side.
After handlebars are assembled they will rotate freely – be cautious. Until the
machine is fully assembled, do not grab the handlebars for support.
UPPER HANDLEBAR
UPPER HANDLEBAR
PRE-ATTACHED SCREWS
PRE-ATTACHED SCREWS
11
6/16/08 2:40:13 PM