Horizon Fitness H-SERIES E5 User Manual page 5

AS SE MB LY ST EP 2
GUIDERAIL CAPS
A) Open HARDWARE BAG FOR STEP 2.
B) Slide MID-STABILIZER FEET into MID-STABILIZER TUBE and attach using 2 SCREWS (E).
D) Slide GUIDERAIL CAPS into the GUDIERAILS to seal the openings.
HARDWARE BAG FOR STEP 2 CONTENTS :

H-series_E5_Rev.1.2.indd 8-9
SCREW (E)
MID-STABILIZER FOOT
MID-STABILIZER TUBE
GUIDERAILS
SCREW (E)
10 mm
Qty: 2
ASSEMBLY STEP 
FOOTPAD
SCREWS (F)
LOWER LINK ARM
A) Open HARDWARE BAG FOR STEP 3.
B) Attach FOOTPAD to PEDAL ARM using 4 SCREWS (F).
C) Align the bracket on the RIGHT LOWER LINK ARM with the tube on the RIGHT PEDAL ARM.
D) Slide the SPACER (R) through the LINK ARM BRACKET and the PEDAL ARM so it can't rotate.
E) Insert 2 WASHERS (S) between the PEDAL ARM and the LINK ARM BRACKET.
F) Secure the joint with 1 FLAT WASHER (U) and 1 BOLT (T).
G) Attach PEDAL ARM to the CRANK with 1 BOLT (G), 1 WASHER (I), 1 WAVY WASHER (D) and 1 WASHER (H).
H) Repeat on other side.
HARDWARE BAG FOR STEP  CONTENTS :
SCREW (F) BOLT (G)
12 mm 13 mm
Qty: 8 Qty: 2
WASHER (S) WASHER (U) WASHER (H)
30 mm 35 mm Qty: 2
Qty: 4 Qty: 2
WASHER (H) WASHER (I) BOLT (G)
CRANK
WAVY WASHER (D)
LINK ARM
PEDAL ARM
WASHERS (S)
BOLT (T)
SPACER (R)
WASHER (U)
BOLT (T) SPACER (R)
15 mm 70 mm
WASHER (H)
Qty: 2 Qty: 2
WASHER (I) WAVY WASHER (D)
CRANK
Qty: 2 Qty: 2
angle view WAVY WASHER (D)
LINK ARM
PEDAL ARM
WASHER (I) BOLT (G)

WASHERS (S)
6/16/08 2:40:08 PM