Horizon Fitness ELLIPTICAL E901 User Manual page 7

ASSEM BLY ST eP 
SPACER (H)
CONNECTING TUBE
RIGHT PEDAL ARM
A Open HArDWAre BAG FOr STeP .
B Align the U-BrACKeT on the riGHT LOWer LiNK Arm with the CONNeCTiNG TUBe on the riGHT
PeDAL Arm.
C Slide the SPACer (H) through the U-BrACKeT and the CONNeCTiNG TUBe so that it can no longer
rotate.
D Insert 2 SPLiT TeFLON WASHerS (i) between the CONNeCTiNG TUBE and the U-BrACKeT.
e Secure the joint with a FLAT WASHer (J) and BOLT (K).
F Repeat on the other side.
HArDWAre BAG FOr STeP  CONTeNTS :
SPLIT TEFLON
WASHER (I)
28 mm
Qty: 4
12
E901_Rev.1.7.indd 12-13
RIGHT LOWER LINK ARM
U-BRACKET
SPLIT TEFLON WASHERS (I)
FLAT WASHER (J)
BOLT (K)
SPACER (H)
72 mm axis
Qty: 2
FLAT WASHER (J) BOLT (K)
35 mm 15 mm
Qty: 2 Qty: 2
ASSEMBLY STeP 
PRE-ATTACHED NUT, FLAT WASHER AND BOLT
LOWER LINK ARM
NOTe: There is no hardware bag for this step
A Remove Pre-ATTACHeD SPACer, SPACer riNGS, BOLTS, FLAT
WASHerS and NUTS from LOWer LiNK Arm.
B Slide Pre-ATTACHeD SPACer into LOWer LiNK Arm.
C Place 2 Pre-ATTACHeD SPACer riNGS on both sides of
Pre-ATTACHeD SPACer. While holding Pre-ATTACHeD SPACer
riNGS, slide LOWer LiNK Arm into bottom end of
LOWer HANDLeBAr.
D Insert 1 Pre-ATTACHeD BOLT into LOWer HANDLeBAr and secure
using 1 Pre-ATTACHeD WASHer and 1 Pre-ATTACHeD NUT.
e Repeat on other side.
LOWER LINK ARM LOWER HANDLEBAR
SPACER RINGS
SPACER
LOWER HANDLEBAR
PRE-ATTACHED SPACER RINGS AND SPACER
Confirm that the
LOWER HANDLEBAR
and the LOWER LINK ARM
are marked R. The left
side is marked L.
1
9/10/08 11:07:03 AM