Horizon Fitness E701 User Manual page 5

ASSE MBLY ST E P 2
BOLTS (C)
SPRING WASHERS (D)
FLAT WASHERS (E)
CONSOLE MAST BOOT
MAIN FRAME
A Open HARDWARE BAG FOR STEP 2.
B Slide CONSOLE MAST BOOT onto the bottom of the CONSOLE MAST above bolt holes as shown.
C Carefully pull the CONSOLE CABLE through the CONSOLE MAST using the twist tie located inside the
CONSOLE MAST.
D Attach the CONSOLE MAST to the MAIN FRAME using 7 BOLTS (C), 7 SPRING WASHERS (D) and 7 FLAT
WASHERS (E). Slide CONSOLE MAST BOOT down to cover MAIN FRAME.
DO NOT PINCH WIRES!
E Attach the WATER BOTTLE HOLDER to the mast using 2 PRE-ATTACHED SCREWS.
HARDWARE BAG FOR STEP 2 CONTENTS :
BOLT (C)
15 mm
Qty: 7

E701_Rev.1.8.indd 8-9
CONSOLE MAST
CONSOLE
MAST
WATER
BOTTLE
HOLDER
PRE-ATTACHED
BOLTS (C)
SCREW
SPRING WASHER (D) FLAT WASHER (E)
15 mm 20 mm
Qty: 7 Qty: 7
ASSEMBLY STEP 
CONSOLE
MAST
CONSOLE
MAST PRE-ATTACHED WASHER,
WAVY WASHER & BOLT
PRE-ATTACHED WASHER,
WAVY WASHER & BOLT
LOWER RIGHT
HANDLEBAR
LOWER RIGHT
HANDLEBAR
NOTE: There is NO hardware bag for this step. All hardware is pre-installed.
A Remove PRE-ATTACHED BOLT & WASHER from CONSOLE MAST.
B Slide LOWER RIGHT HANDLEBAR onto CONSOLE MAST and attach by re-inserting PRE-ATTACHED WASHER
& BOLT.
C Remove PRE-ATTACHED SET SCREWS from right UPPER HANDLEBAR.
D Slide right UPPER HANDLEBAR onto right LOWER HANDLEBAR and secure by reinserting PRE-ATTACHED
SET SCREWS.
After handlebars are assembled they will rotate freely – be cautious. Until
WARNING
the machine is fully assembled, do not grab the handlebars for support.
E Snap the front and back HANDLEBAR COVERS together onto the HANDLEBARS.
Note the position of the snap tabs on the covers before snapping into position.
F Repeat on other side.
UPPER RIGHT
HANDLEBAR
UPPER RIGHT
HANDLEBAR
PRE-ATTACHED SCREWS
PRE-ATTACHED SCREWS
HANDLEBAR
COVERS
HANDLEBAR
COVERS

9/10/08 11:05:15 AM