Horizon Fitness E401 User Manual page 5

AS SE MB LY ST EP 2
BOLT (A)
SPRING WASHER (B)
FLAT WASHER (C)
TOP FRONT COVER
A Open HARDWARE BAG FOR STEP 2.
B Carefully pull the CONSOLE WIRES through the CONSOLE MAST using the twist tie located inside the
CONSOLE MAST.
C Attach the CONSOLE MAST to the MAIN FRAME using 4 BOLTS (A), 4 SPRING WASHERS (B) and 4 FLAT
WASHERS (C).
D Insert the TOP FRONT COVER, followed by the TOP BACK COVER and snap them together.
E Slide CONSOLE MAST BOOT down to seal the console mast hole.
DO NOT PINCH WIRES!
HARDWARE BAG FOR STEP 2 CONTENTS :

E401_Rev.1.5.indd 8-9
ASSEMBLY STEP 
CONSOLE MAST
CONSOLE MAST BOOT
CONSOLE WIRES
TOP BACK COVER
MAIN FRAME
NOTE: There is NO hardware bag for this step. All hardware is pre-installed.
A Remove PRE-ATTACHED BOLT & WASHERS from CONSOLE MAST.
B Slide LOWER HANDLEBARS onto CONSOLE MAST and attach by re-inserting PRE-ATTACHED BOLT &
WASHERS.
C Slide UPPER HANDLEBARS onto LOWER HANDLEBARS and align NOTCH with TAB making sure handlebars
are joined together completely. Secure UPPER HANDLEBARS to LOWER HANDLEBARS using PRE-ATTACHED
SET SCREWS.
D Repeat on other side.
UPPER HANDLEBAR
NOTCH
PRE-ATTACHED
CONSOLE MAST SET SCREWS
TAB
PRE-ATTACHED
BOLT & WASHER
LOWER HANDLEBAR
After handlebars are assembled they will rotate freely – be cautious. Until the
machine is fully assembled, do not grab the handlebars for support.

2/29/08 10:05:32 AM