Horizon Fitness E1200 User Manual page 5

AS SE MB LY ST EP 1
A) Open HARDWARE BAG FOR STEP 1.
B) Attach the FRONT STABILIZER TUBE to the MAIN FRAME using 2 BOLTS (A).
HARDWARE BAG FOR STEP 1 CONTENTS :

E900_E1200_Rev.2.7.indd 8-9
BOLT (A)
FRONT STABILIZER TUBE
MAIN FRAME
BOLT (A)
20 mm
Qty: 2
ASSEMBLY STEP 2
CONSOLE WIRES
BOLT (B)
CONSOLE MAST BOOT
SPRING WASHER (C)
ARC WASHER (E)
PRE-ATTACHED BOLT (B)
ALIGNMENT BOLT
SPRING WASHER (C)
FLAT WASHER (D)
CONSOLE MAST
MAIN FRAME
A. Open HARDWARE BAG FOR STEP 2.
B. Remove PRE-ATTACHED ALIGNMENT BOLT from CONSOLE MAST.
C. Slide CONSOLE MAST BOOT onto the bottom of the CONSOLE MAST.
D. Put ALIGNMENT BOLT back into CONSOLE MAST, screwing it in only half way.
E. Carefully pull the CONSOLE WIRES through the CONSOLE MAST using the twist tie located inside the
CONSOLE MAST.
F. Attach the CONSOLE MAST to the MAIN FRAME using 6 BOLTS (B), 6 SPRING WASHERS (C),
4 FLAT WASHERS (D) and 2 ARC WASHERS (E).
DO NOT PINCH WIRES!
G. Attach the WATER BOTTLE HOLDER to the mast using 2 BOLTS (F).
HARDWARE BAG FOR STEP 2 CONTENTS :
BOLT (B) SPRING WASHER (C)
20 mm 15 mm
Qty: 6 Qty: 6
ARC WASHER (E)
17 mm
Qty: 2
angle view
WATER BOTTLE HOLDER
BOLTS (F)
CONSOLE MAST
FLAT WASHER (D)
18 mm
Qty: 4
BOLT (F )
12 mm
Qty: 2
9
6/16/08 9:45:39 AM