Replacing The Fan Cage Assembly - IBM System x3500 Installation And User Manual

4. Reconnect the cables and power cords (see "Connecting the cables" on page
5. Update the server configuration (see "Updating the server configuration" on
6. Install the server in the rack cabinet (see the Tower to Rack Installation
7. Slide the server back into the rack, if necessary.
8. Start the server. Confirm that it starts correctly and recognizes the newly
9. (IBM Business Partners only) Complete the additional steps in "Instructions for

Replacing the fan cage assembly

To replace the fan cage assembly, complete the following steps.
Attention:
correctly before you install the fan cage assembly. Wiring that is not properly routed
might be damaged or might prevent the fan cage assembly from seating properly in
the server.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Align the guides on the fan cage with the release latch to the open position on
3. Push the fan cage assembly into the server.
4. Rotate the fan cage release latch to the close position. The fan cage will be fully
110
IBM System x3500 M4 Type 7383: Installation and User's Guide
114).
page 115).
Instructions that come with the server for instructions).
installed devices, and make sure that no error LEDs are lit.
IBM Business Partners" on page 29.
Make sure that all wires and cables inside the server are routed
on page 37.
each side.
Note: Make sure that the fan cage is fully seated.
seated when it is secured.