Installing A Dvd Drive - IBM System x3500 Installation And User Manual

2. Turn off the server and peripheral devices, and disconnect the power cords and
3. Unlock the left-side cover.
4. Open the bezel (see "Opening the bezel media door" on page 58).
5. Remove the filler panel, if one is present.
6. Touch the static-protective package that contains the drive to any unpainted
7. Grasp the black drive handle and slide the blue release latch to the right and
8. Gently push the drive into the bay until the drive stops.
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 109.

Installing a DVD drive

To install the DVD drive, complete the following steps:
74
IBM System x3500 M4 Type 7383: Installation and User's Guide
all external cables.
Note: You must unlock the left-side cover to open or remove the bezel. When
you lock the left-side cover, it locks both the cover and the bezel.
metal surface on the server; then, remove the drive from the package and place
it on a static-protective surface.
align the drive assembly with the guide rails in the bay.
1. If you are replacing a drive, make sure that:
v You have all the cables and other equipment that are specified in the
documentation that comes with the new drive.
v You have checked the instructions that come with the new drive to
determine whether you must set any switches or jumpers in the drive.
v You have removed the blue optical drive rails from the side of the old drive
and have them available for installation on the new drive.
Note: If you are installing a drive that contains a laser, observe the following
safety precautions.
Statement 3: