Hoover SAVVY Turbo POWER Upright Vacuum Cleaner Owner's Manual page 5

2-3
Transporting cleaner
Put handle in upright position. Tilt clean-
er back on rear wheels. Push forward.
2-6
B
Carpet height
adjustment
The cleaning of carpet and rugs takes
place at the nozzle (A).
When it is necessary to raise and lower the
nozzle for various carpet pile heights, turn
the nozzle control knob (B) to the desired
setting.
2-4
Carrying cleaner
Use the carrying handle to lift the
cleaner.
Do not lift cleaner using dirt cup
handle (A).
2-7
A
Settings
For maximum cleaning performance,
the following carpet height settings are
recommended.
Low/Hard Surface: for bare floors and all
types of carpet
Note: If the cleaner is difficult to push, turn
knob to the next higher setting.
High Pile: for very deep pile carpet where
easier pushing effort is desired, while
maintaining good cleaning performance.
2-5
A
Handle positions
The handle of your cleaner has three
positions; upright for storage and when
using cleaning tools; operating posi-
tion for general operation on carpet
and floors; low for reaching under low
furniture. Step on handle release lever
to lower handle.
2-8
Cleaning lightweight
flexible rugs
Stand on one end of rug and move
cleaner toward other end or edge.
Before reaching edge, push down on
handle. This will lift up the nozzle (front
of cleaner) and will prevent rug from
clinging to cleaner. Continue to lift up
nozzle so that when you have reached
the edge, it is completely off the rug.
Move cleaner back to start again, lower
nozzle, and use only forward strokes.
Continued
5