93). Tip: Tighten The Two Screws In The Front - NordicTrack COMMERCIAL VR User Manual

7. Attach the Seat (9) to the Seat Carriage (41)
with four M6 x 16mm Screws (71) and four M6
Washers (88). Note: Only two Screws and two
Washers are shown.
8. Have another person hold the Upright (2) near
the Frame (1).
See the inset drawing. Locate the wire tie in
the Upright (2). Tie the lower end of the wire tie
to the Main Wire Harness (43) and to the Upper
Pulse Wire (42). Next, pull the upper end of the
wire tie upward out of the top of the Upright.
Then, untie and discard the wire tie. Tip: Do
not allow the ends of the wires to fall into
the Upright. Use a piece of tape or an elastic
band to hold the wires in place until step 10.
Tip: Avoid pinching the wires. Attach the
Upright (2) to the Frame (1) with four M8 x
18mm Screws (67) and four M8 Split Washers

(93). Tip: Tighten the two Screws in the front

of the Upright and then tighten the other two
Screws.
9. Identify the Right Handlebar (20).
Attach the Right Handlebar (20) to the Upright
(2) with two M8 x 18mm Screws (67) and two M8
Split Washers (93).
Attach the Left Handlebar (7) in the same
way.
7
8
42
43
67
93
Wire
Tie
43
42
9
7
2
10
9
41
88
71
Avoid pinching
the wires
2
67
93
93
93
67
1
93
20
67